Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SNMP error traps

I get the below or my router even after replacing theh Sup:

%SYS-4-MGDTIMER = %p

Software: boot system flash

disk0:s72033-jk9o3sv-mz.122-17d.SXB8.bin

Hardware:CISCO7609

Supervisor card:WS-SUP720-3B

Thanx

May

1 REPLY

Re: SNMP error traps

SYS-4-MGDTIMER

SEVERITY: Error

FORMAT: "%s%s, timer = %p."

FLAG: Stack Trace

THROTTLING: Ten Seconds

EXPLANATION: "A software or hardware error occurred. This is an internal error while manupulating the internel resource Managed Timer. If it persists still, this needs to be analysed by the development team."

RECOMMENDED ACTION: Copy the error message exactly as it appears in the system log, call your Cisco technical support representative and provide the representative with the gathered information.

REQUIRED INFO: Capture the following and contact your technical support representative.

a) dspcds

b) dspcd

c) dsperr

d) dsplog

e) dspred

f) dir "ERPM"

HTH

Narayan

102
Views
0
Helpful
1
Replies