Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SNMP ipNetToPhysicalPhysAddress only shows ipv6 addresses

Hi,

we currently have a problem with a software which is listing up devices with the mac and ip address.

The developer of the software is using snmp ipNetToPhysicalPhysAddress (OID 1.3.6.1.2.1.4.35.1.4).

Unfortunately a snmpwalk only provides some ipv6 addresses but non ipv4 addresses.

 

We are using two 3850-24T in a stack, IOS version is 03.03.04SE

Is there a know issue with the ipNetToPhysicalPhysAddress entries?

 

Thanks in advance

Johannes

1 REPLY
New Member

Hi,can nobody help me

Hi,

can nobody help me?

Johannes

24
Views
0
Helpful
1
Replies