Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Webcast- Automate Nexus9k

Highlighted
Community Member

SNMP MIBs and Traps on C2960

Any default enabled SNMP traps on C2960? User has to configure every single event, including port/link UP/Down, packet loss, overload status for an SNMP server to automatically be notified these trap events?

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

Re: SNMP MIBs and Traps on C2960

You can turn on all traps at once , there not on by default but can all be enabled at once if thats what you want or else manually select the ones you want

(conf t) snmp-server enable traps

then do all interfaces at once in range if you want int notifications

int r g1/0/1 - 24
logging event link-status

1 REPLY
VIP Purple

Re: SNMP MIBs and Traps on C2960

You can turn on all traps at once , there not on by default but can all be enabled at once if thats what you want or else manually select the ones you want

(conf t) snmp-server enable traps

then do all interfaces at once in range if you want int notifications

int r g1/0/1 - 24
logging event link-status

140
Views
0
Helpful
1
Replies
CreatePlease to create content