Does anybody know of an OID to measure the inlinepower of a card (I specifically want to get the readout from the below marked in bold):
#sh powe
Load for five secs: 2%/5%; one minute: 2%; five minutes: 2%
Time source is NTP, 07:14:05.157 UTC Fri Sep 27 2013
system power redundancy mode = redundant
system power total = 3795.12 Watts (90.36 Amps @ 42V)
system power used = 1144.92 Watts (27.26 Amps @ 42V)
system power available = 2650.20 Watts (63.10 Amps @ 42V)
Power-Capacity PS-Fan Output Oper
PS Type Watts A @42V Status Status State
---- ------------------ ------- ------ ------ ------ -----
1 WS-CAC-4000W-INT 3795.12 90.36 OK OK on
2 WS-CAC-4000W-INT 3795.12 90.36 OK OK on
Pwr-Allocated Oper
Fan Type Watts A @42V State
---- ------------------ ------- ------ -----
1 WS-C6509-E-FAN 150.36 3.58 OK
Pwr-Requested Pwr-Allocated Admin Oper
Slot Card-Type Watts A @42V Watts A @42V State State
---- ------------------ ------- ------ ------- ------ ----- -----
1 WS-X6148A-45AF 49.56 1.18 49.56 1.18 on on
3 WS-X6148A-45AF 49.56 1.18 49.56 1.18 on on
5 WS-SUP32-GE-3B 154.98 3.69 154.98 3.69 on on
6 WS-SUP32-GE-3B 154.98 3.69 154.98 3.69 on on
8 WS-X6148A-45AF 49.56 1.18 49.56 1.18 on on
Inline Inline Inline Inline
Pwr-Requested Pwr-Allocated Local-Pwr-Pool Power
Slot Card-Type Watts A @42V Watts A @42V Watts A @42V Status
---- ------------------ ------- ------ ------- ------ ------- ------ ----------
1 WS-F6K-48-AF 113.40 2.70 127.40 3.03 34.61 0.82 On
3 WS-F6K-48-AF 144.90 3.45 162.79 3.88 34.61 0.82 On <<<---------- this bit
8 WS-F6K-48-AF 126.00 3.00 141.56 3.37 34.61 0.82 On
on a 6500 running old code.
#sh ver
Load for five secs: 2%/6%; one minute: 1%; five minutes: 2%
Time source is NTP, 07:19:15.425 UTC Fri Sep 27 2013
Cisco IOS Software, s3223_rp Software (s3223_rp-IPSERVICESK9_WAN-VM), Version 12.2(33)SXH5, RELEASE SOFTWARE (fc1)
Thanks,
Ian
