Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SNMP V.3 Configuration.

Hi All,

I need some clarification about the snmp v3 configuration.

The below configuration is correct / i can proceed this.

access-list 99 permit 1.1.1.1!!LMS Server!!

access-list 99 permit 2.2.2.2!! CSMARS Server!!

!

snmp-server group test v3 auth access 99

!

Note: Below commands will not see in the running config; whether i have to apply the same commands  for csmars also?!!

snmp-server user test test123  remote 1.1.1.1v3 auth md5 test234

snmp-server user test test123  v3 auth md5 test234 priv des test234

snmp-server host 1.1.1.1 test !! Points to LMS Server!!This same commands  have to points to csmars?

!

If somebody have best practise Snmp trap configuration send it ..

1 REPLY
New Member

Re: SNMP V.3 Configuration.

snmp-server view ABC-view internet included
snmp-server group SNMP-Group v3 auth read/write ABC-view access 15(access-list)
snmp-server user CISCO SNMP-Group v3 auth md5 password priv des password access 15(access-list)

access-list 15 permit host 172.16.X.X
access-list 15 permit host 172.16.X.X
access-list 15 permit host 172.16.X.X
access-list 15 permit host 172.16.X.X

snmp-server host 172.16.X.X traps version 3 auth CISCO

and enable SNMP traps with snmp-server enable traps cmd

Hope this will help!!!

Thanks/Bhisham

273
Views
0
Helpful
1
Replies