I need to upgrade the SNMP version on our switch so I can capture more information from the switch. I need to find the process to upgrade to SNMP version 3 and how to make sure it is safe. I only need it open to one server that will e gathering the information. The switch we use are Cisco 2960 and we are running SNMP version 2.
Check the configuration guide, it covers SNMPv3 as well as your auth and priv options. If you want both auth and priv (suggested) it does require the k9 image. Post a show inventory if you need help selecting the correct IOS.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...