Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Bronze

Solarwinds showing interfaces with receive errors and discards errors but switchports are clean

  • LAN Switching and Routing
3 REPLIES
Hall of Fame Super Gold

Re: Solarwinds showing interfaces with receive errors and discar

Last clearing of "show interface" counters 08:19:50

In both interfaces, someone's cleaned out the counters.

Try "sh interface summary".

Bronze

Re: Solarwinds showing interfaces with receive errors and discar

Yes, we cleared the counters every morning...the errors as reported by Solarwinds were seen intra day (i.e. after the counters were cleared).

sh int g1/27 sum

*: interface is up
IHQ: pkts in input hold queue     IQD: pkts dropped from input queue
OHQ: pkts in output hold queue    OQD: pkts dropped from output queue
RXBS: rx rate (bits/sec)          RXPS: rx rate (pkts/sec)
TXBS: tx rate (bits/sec)          TXPS: tx rate (pkts/sec)
TRTL: throttle count

  Interface           IHQ   IQD  OHQ   OQD  RXBS RXPS  TXBS TXPS TRTL
---------------------------------------------------------------------
* GigabitEthernet1/2    0     0    0     0     0    0  1000    1    0
NOTE:No separate counters are maintained for subinterfaces
     Hence Details of subinterface are not shown


sh int g1/35 sum

*: interface is up
IHQ: pkts in input hold queue     IQD: pkts dropped from input queue
OHQ: pkts in output hold queue    OQD: pkts dropped from output queue
RXBS: rx rate (bits/sec)          RXPS: rx rate (pkts/sec)
TXBS: tx rate (bits/sec)          TXPS: tx rate (pkts/sec)
TRTL: throttle count

  Interface           IHQ   IQD  OHQ   OQD  RXBS RXPS  TXBS TXPS TRTL
---------------------------------------------------------------------
* GigabitEthernet1/3    0     0    0     0  2000    3  5000    8    0

Attached you will find the output of sh counters g1/27 & g1/35

Bronze

Re: Solarwinds showing interfaces with receive errors and discar

come to think of it. Solarwinds is not reporting on the switch level but the server level. So, it might be a problem with the server and not on the switch.

3133
Views
0
Helpful
3
Replies