Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Some PoE ports don't work on Cisco Catalyst 3560

Hi.

My problem is the following.

A switch Cisco Catalyst 3560 of one of our customers, model WS-C3560G-24PS-S, have three ports (3, 4 and 6) that don't give PoE. The other ports work fine.

I've reviewed power inline parameters, and where I run debug of power inline events, at the connect IP Phone the ports don't show neither activity, but if I connect the IP Phone to a port other than 3,4 or 6 ports, this power on.

I'm attaching de show tech of this switch.

Thanks in advance for the help,

Ramiro Marulanda

Everyone's tags (4)
1 REPLY
VIP Super Bronze

Re: Some PoE ports don't work on Cisco Catalyst 3560

Hi,

Looking at your config ports 3,4 and 6 are configured just as any other port.  This looks as to be a hardware issue.  I would open a ticket with TAC and RMA the device.

HTH

Reza

1179
Views
0
Helpful
1
Replies
CreatePlease to create content