In my set up, I have a Cisco 3560 Layer 3 switch in which I have created 4 vlans (say 192.168.1.0/24, 192.168.2.0/24, 192.168.3.0/24, 192.168.4.0/24) and above that I have 2 Cisco routers (say A and B). In my current setup, by default, all traffic goes to my Cisco A through my Linux gateway. Is it possible for me to do source based routing in my Layer 3? I would like to route traffic from one particular vlan alone (say 192.168.3.0/24 vlan) or one particular host from a vlan to my router B. How can I do this otherwise if I can't do source based routing...
i am not able to apply the route-map in the vlan interface. Seems there is no such command under vlan. Below are my options coming up under vlan.
Switch3560(config)#interface vlan 50
Switch3560(config-if)#ip ? Interface IP configuration subcommands: access-group Specify access control for packets accounting Enable IP accounting on this interface address Set the IP address of an interface admission Apply Network Admission Control authentication authentication subcommands bandwidth-percent Set EIGRP bandwidth limit broadcast-address Set the broadcast address of an interface cef Cisco Express Forwarding interface commands dhcp Configure DHCP parameters for this interface directed-broadcast Enable forwarding of directed broadcasts hello-interval Configures IP-EIGRP hello interval helper-address Specify a destination address for UDP broadcasts hold-time Configures IP-EIGRP hold time information-reply Enable sending ICMP Information Reply messages irdp ICMP Router Discovery Protocol load-sharing Style of load sharing local-proxy-arp Enable local-proxy ARP mask-reply Enable sending ICMP Mask Reply messages next-hop-self Configures IP-EIGRP next-hop-self probe Enable HP Probe support proxy-arp Enable proxy ARP rarp-server Enable RARP server for static arp entries redirects Enable sending ICMP Redirect messages rip Router Information Protocol route-cache Enable fast-switching cache for outgoing packets security DDN IP Security Option split-horizon Perform split horizon summary-address Perform address summarization unnumbered Enable IP processing without an explicit address unreachables Enable sending ICMP Unreachable messages vrf VPN Routing/Forwarding parameters on the interface
Switch3560(config-if)#ip po Switch3560(config-if)#ip policy route-map net_access ^ % Invalid input detected at '^' marker.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...