I have a router cisco 7604 VXR with two outside connections, each one associated to a set of addresses. I have defined a default gateway for one of the set of addresses and a source routing to define the gateway for the other set but it doesn't work. The configuration is:
interface FastEthernet0/1.5 encapsulation dot1Q 5 ip address 18.104.22.168 255.255.255.224 ip flow monitor flow-monitor-smart-1 output ip flow ingress ip flow egress ip policy route-map CCA_GATEWAY ip ospf message-digest-key 1 md5 7 1A4D169404421B1F027A7A
access-list 101 permit ip 22.214.171.124 0.0.0.31 any
route-map CCA_GATEWAY permit 10 match ip address 101 set ip default next-hop 172.31.50.2 (address of the next router. I arrive to it)
When I do a show route-map CCA_GATEWAY I see that "the number of policy routing matches" increase but the router is sending the packets to the wrong gateway.
route-map CCA_GATEWAY, permit, sequence 10 Match clauses: ip address (access-lists): 101 Set clauses: ip default next-hop 172.31.50.2 Policy routing matches: 2336130 packets, 2068948582 bytes
I am glad that my suggestion did help you to resolve your problem. Thank you for posting back to the forum indicating that the problem was solved (and thank you for the rating). It makes the forum more useful when people can read about a problem and can tell from the marking of the post that they will read suggestions which lead to the solution of the problem.
I encourage you to continue your participation in the forum.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...