I want to source a single multicast packet from a loopback interface every 30 seconds.
I used the following configuration:
ip sla 1 udp-echo 188.8.131.52 6666 source-ip 10.102.78.1 control disable timeout 0 frequency 30 ip sla schedule 1 life forever start-time now
(10.102.78.1 = source ip loopback)
However, if i look down in my multicast network, it seems the switch is sourcing a single packet from EVERY active interface.
He is not sourcing a single packet from lo0 every 30 seconds, but a single packet every 30 seconds, on each active ip interface.
Anyone know how to prevent this ?
(running 12.2(33)SXI1 on C6500)
#sh ip mroute 184.108.40.206 IP Multicast Routing Table Flags: D - Dense, S - Sparse, B - Bidir Group, s - SSM Group, C - Connected, L - Local, P - Pruned, R - RP-bit set, F - Register flag, T - SPT-bit set, J - Join SPT, M - MSDP created entry, X - Proxy Join Timer Running, A - Candidate for MSDP Advertisement, U - URD, I - Received Source Specific Host Report, Z - Multicast Tunnel Y - Joined MDT-data group, y - Sending to MDT-data group Outgoing interface flags: H - Hardware switched, A - Assert winner Timers: Uptime/Expires Interface state: Interface, Next-Hop or VCD, State/Mode
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...