Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

SPAN 2960

After configuring SPAN on 2960, IDS can't connect to anything, IDS & PC client same switch on 2960

Please correct the below configuration.

interface GigabitEthernet0/1

description " To L3 3750"

switchport mode trunk

!       

interface GigabitEthernet0/11

description "PC client"

switchport access vlan 8

!

interface GigabitEthernet0/11

description " To IDS"

switchport access vlan 8

monitor session 1 source interface Gi0/2

monitor session 1 destination interface Gi0/3

Switch#sh monitor

Session 1

---------

Type                        : Local Session

Source Ports            :

Both                        : Gi0/2

Destination Ports      : Gi0/3

Encapsulation          : Native

Ingress                    : Disabled

2 REPLIES
Cisco Employee

SPAN 2960

check the output rate on the destination interface. 2960 uses shared buffer. Make sure the span is not overwhelming the buffer available.

Thanks & Regards,
Karthick Murugan
CCIE#39285

Thanks & Regards, Karthick Murugan CCIE#39285
Community Member

Hi All,Is there supported

Hi All,

Is there supported document that said about buffer/cpu consumption at Cat-2960 during running SPAN monitor ?

 

Thanks,

Rakhmad

81
Views
0
Helpful
2
Replies
CreatePlease to create content