Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SPAN Configuration

I have configure my 3750 switch for span. In this switch my IPS 4255, Internet router and Pix firewall is connected.

Below mention is the span configuration

monitor session 1 source interface Gi1/0/1 - 3

monitor session 1 destination interface Gi1/0/5

now the problem is the that IPS capturing traffic twice once while going out and once while coming in.

I wana know how to configure monitor session that it only capture traffic that is coming from Internet. Not traffic that

is originating from inside of the network.

In switch port 1 Internet router is connected, port 2 is for firewall and three is for concentrator.

I m confuse about the span port configuration either Rx or Tx. Right it is both Rx and Tx.

1 REPLY
New Member

Re: SPAN Configuration

Specify 'rx' on the interface(s) on which you wish to mirror inbound traffic:

monitor session 1 source interface g1/0/1 rx

Rx captures traffic entering the interface, Tx captures traffic leaving the interface.

107
Views
0
Helpful
1
Replies