In N7K has SVI for VLAN 115 & 135 and N5Ks has L2 VLAN for 115 & 135.
Requirement is to SPAN all the traffic leaving IN/OUT of both VLANS needs to forwarded to Ethanalyzer which is connected in N5K.
If I configure SPAN in 5K will it capture all the traffic both IN/OUT traffic in those both VLANS. Nexus 7K has the gateway but no servers are connected on that switch. By configuring SPAN in 5K will it fulfil our requirement ?
If not then can i configure ERSPAN source in Nexus 5K and move my Ethanalyzer to Nexus 7K and make that port as ERSPAN destination ? Will this work out ?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...