07-12-2010 03:49 AM - edited 03-06-2019 11:59 AM
Hello All,
I want to configure SPAN on 6500 series for SNORT IDS, it has multiple Vlan and all Vlan are of layer 2, Can you please guide me how can I achieve this?
Thanks in anticipation
Jagdev
Solved! Go to Solution.
07-12-2010 04:46 AM
Hi Jagdev,
Following configuration will work for local span and will give all traffic
output on the destination port which you have configured Gi9/10
Hope to Help !!
Ganesh.H
Remember to rate the helpful post
=====
07-12-2010 04:08 AM
Hello All,
I want to configure SPAN on 6500 series for SNORT IDS, it has multiple Vlan and all Vlan are of layer 2, Can you please guide me how can I achieve this?
Thanks in anticipation
Jagdev
Hi Jagdev,
Check out the belowl ink for span configuration on 6500 series switches
Hope to Help !!
Ganesh.H
Remember to rate the helpful post
07-12-2010 04:35 AM
Hi Ganesh,
Thanks for reply, As per the document and my knoweldge i can configure SPAN as i have given configuration example bleow, and that should not make any raise in CPU utilization as 6500 deos not use CPU to switch Packets or mirror packets.
monitor session 1 source Vlan 1-100 , 350
monitor session 1 destination interface G9/10
am i right and can i go ahead with this configuration?
Regards
Jagdev
07-12-2010 04:46 AM
Hi Jagdev,
Following configuration will work for local span and will give all traffic
output on the destination port which you have configured Gi9/10
Hope to Help !!
Ganesh.H
Remember to rate the helpful post
=====
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide