Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

span port configuration to listen to specific traffic only

Hi all,

Is it possible to configure the span(switch port analyzer) port and restrict it to only listen to ingress and egress of TCP/1433 from the source port?

Pls advise, thks in advance.

2 REPLIES
Community Member

span port configuration to listen to specific traffic only

Hi don li,

I dont think you'll be able to to use SPAN to listen on specific port. but you can use VACL, but that will depend on the model of your switch.

http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a008015c612.shtml

HTH.

Regards,

Terence

Purple

span port configuration to listen to specific traffic only

Hi,

you'll have to configure a capture filter on your packet analysis software.

Regards.

Alain.

Don't forget to rate helpful posts.
304
Views
0
Helpful
2
Replies
CreatePlease to create content