Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

span & rspan together

i tried to configure RSPAN & SPAN as source in same monitor   session,  i get below error. is that mean we cannot configure SPAN  &  RSPAN as source in same monitor session

"% Cannot add RSPAN VLAN as source for SPAN session 1 as it is not a RSPAN Destination session     "

my intention is to replicate all  the vlan 61 & 73 receiving packet in both switches to snifer connected to DAS-SW4 fa 0/12

configuration as below

DAS-switch1

-----

vlan 101

remote-span

monitor sess 1 source vlan 61 73 rx

monitor sess 1 destination remote vlan 101

DAS-SW4

---------

vlan 101

remote-span

DAS-SW4#monitor session 1 source vlan 61 ,73 rx

DAS-SW4(config)#monitor session 1 source vlan 61 ,73 rx

DAS-SW4(config)#monitor session 1 source remote vlan 101

% Cannot add RSPAN VLAN as source for SPAN session 1 as it is not a RSPAN Destination session      

DAS-SW4(config)#monitor session 1 destination interface Fa0/12

1 REPLY
Cisco Employee

span & rspan together

Hi,

no you cannot mix span and rspan sources in the same monitor session

check all span,rspan,erspan limitations here (if you have a 7600)

http://www.cisco.com/en/US/partner/docs/routers/7600/ios/12.2SR/configuration/guide/span.html#wp1103291

Riccardo

433
Views
0
Helpful
1
Replies