I have an issue trying to capture IGMP reports from a client. I can see the IGMP queries and multicast towards the client. The client is also sending out multicast which I can see, but IGMP reports from the client are not showing up.
Cisco 3560G version 12.2(37)SE
switchport access vlan 226
switchport mode access
no ip igmp snooping tcn flood
no ip address
monitor session 1 source interface Gi0/6
monitor session 1 destination interface Gi0/12
The client is sending out IGMP reports:
226 188.8.131.52 igmp Gi0/6
Monitoring with Wireshark 1.10.2 and Intel 82567LM Gigabit Network adapter.
Thank you for reaching the Small Business Support Community.
I am afraid to tell you you posted your request for support on the wrong community forum, the Cisco3560 is considered an enterprise device and therefore I suggest you to move over this post to the "LAN, Switching and Routing" forum using the "Action" panel on the top right corner of this window or just open up a new threat;
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.