I'm capturing traffic with wireshark and when I capture a VLAN all I see is the source VLAN and destination is broadcast. Why do I not see traffic to other vlans? I would think I would see traffic from the VLAN going to the server VLAN (exchange, file servers, ect) and internet traffic.
Here is how I have the SPAN configured. The switch is a 2960-x
Session 1 --------- Type : Local Session Source VLANs : Both : 110 Destination Ports : Gi2/0/15 Encapsulation : Native Ingress : Disabled
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...