Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

SPAN with Layer-3 Links to Core/Distribution

Hi

I have a question regarding SPAN with Layer-3 link to Core/Distribution?

The topology is as under:

<IP-Phone>-----<cat3560>------<cat6500>------<3570>------<recording-server>

Cat3560s are configured with Data and Voice VLANs

There are 5 x 3560 connected with using layer-3 uplinks to cat6500. Now if SPAN is configured the port goes down is promiscuous mode and causes traffic. Cat6500 are in building 2 where as 3560s are in building 1. RSPAN is not applicable due to layer-3 uplinks. Another option could be RITE, but it is not supported on 3560 switches.

Traffic need to be sniffed for voice vlan for specific phones.

Any suggestions

regards,

Khalid

1 REPLY

Re: SPAN with Layer-3 Links to Core/Distribution

solution - put the recording server closer to the ports/vlans in question.

HTH>

Andrew.

361
Views
0
Helpful
1
Replies