Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Spanning a port on a 4506

I have Catalyst 4506 at the core and have a VLAN for all my servers ( about 100 servers ). I want to create a span (monitor) session to send all the traffic from my server vlan to a gigabit port on the 4506. My questions is: a) Will this have any negative performance hit on my 4506 as there it involves a large amount of traffic, and b) would the gigabit port be able to handle all the traffic from this entire vlan?

Any suggestions will be greatly appreciated.

Sayed

2 REPLIES
Purple

Re: Spanning a port on a 4506

You have 100 servers and you want to span all that info to a single port ? More than likely you will overwhelm the span port which will give you inacurate info if you are trying to use this for a monitoring purpose.

New Member

Re: Spanning a port on a 4506

a) This will have negative impact if the server network transaction is a lot, the swith would have to copy of the packets received or transmitted by the source interfaces and sent to the destination interface.

b) The gig port would only be able to handle traffic incase the total volume (spanned) is less than 80% of the port capacity.

In Addition, the destination device would not be able to handle such huge volume and would rather not provide any meaningful information.

127
Views
8
Helpful
2
Replies