Hi have two distribution switches and have priorites set for different vlans e.g mt_cs_1 will have spanning-tree vlan
1,3,7,9,11,13,15,17,21,50-51,53 priority 8192 and mt_cs_2 will have spanning-tree vlan2,4,6,8,10,12,14,16,18,20,22,32,52,114 priority 8192 configured.
On switch 20_s_1 20_s_2 and 20_s_3 about 70% are vlan 20 and the rest are differnt vlans i.e 50,51,52,53. GI have worked out the route that vlan 20 takes to get to its destination, but how do i know it is the best route. Not sure if i have a spanning tree issuse as the network can slow down time to time. In the diagram where the switches are connected in 3's these are joined in a giagstack half duplex. On the 20th floor switches i recently changed the gigastack to gigbic fibre and awaiting to see if i recieve any colliusion.Please help and point me in the correct direction
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...