Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Spanning-Tree hop counts

I need to make an layer 2 extension of network between two sites, then, would I like to know the maximum number of hops of spanning-tree and if these hops are counted from root bridge?

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: Spanning-Tree hop counts

Based on the documentation http://www.cisco.com/warp/public/473/122.html, your diameter is greater than 7.

Hope this helps.

Regards,

Bill.

3 REPLIES

Re: Spanning-Tree hop counts

Hi Friend,

All default spanning tree specifications are designed with a domain size(hops) of 7.

HTH, rate if it does

Narayan

New Member

Re: Spanning-Tree hop counts

Hi,

It follows the attached network diagram.

I am extending one vlan for three sites, then, the hops should be added from root bridge or end-the-end?

You would be able to me send a link that speaks about domain size (hops) spanning tree.

Thanks,

Fabiano

New Member

Re: Spanning-Tree hop counts

Based on the documentation http://www.cisco.com/warp/public/473/122.html, your diameter is greater than 7.

Hope this helps.

Regards,

Bill.

472
Views
0
Helpful
3
Replies
CreatePlease login to create content