Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Spanning-tree issue

Hi Guys

I have got a weird issue. A switch I have nominated does not appear to be forwarding for a particular vlan over a trunk (please see below).

Port Mode

Encapsulation Status Native vlan

Gi0/46 on 802.1q trunking 1

Gi0/48 on 802.1q trunking 1

Po1 on 802.1q trunking 1

Po2 on 802.1q trunking 1

Port Vlans allowed on trunk

Gi0/46 1,31

Gi0/48 1-4094

Po1 1-4094

Po2 1-4094

Port Vlans allowed and active in management domain

Gi0/46 1,31

Gi0/48 1,30-31,71,73

Po1 1,30-31,71,73

Po2 1,30-31,71,73

Port Vlans in spanning tree forwarding state and not pruned

Gi0/46 1,31

Gi0/48 1,30-31,71,73

<strong>Po1 1</strong> (issue is here not forwarding VLAN31)

Port Vlans in spanning tree forwarding state and not pruned

Po2 1,30-31,71,73

The switch is connected to another switch using a 3Gbps etherchannel... but for some reason does not want to forward this vlan. It is causing another issue as a different interface on both switches then goes off to two other switches and certain devices attached to these cannot communicate (all on VLAN31). I think this is causing the issue but am not sure how to fix it.

I have checked the trunk links and the vlans allowed, etc but cannot see anything obvious?

Any ideas? Thanks

4 REPLIES

Re: Spanning-tree issue

post the output of "show span vlan 31" on the switch that is having the issue

Re: Spanning-tree issue

post the output of "show span vlan 31" on the switch that is having the issue

Purple

Re: Spanning-tree issue

If this is a transparent setup make sure the layer 2 vlan for vlan 31 is created on each switch . Verify on each switch with the show vlan command and make sure vlan 31 shows active.

New Member

Re: Spanning-tree issue

Guys

I shut down the portchannel between the two switches, re-enabled and the VLAN is now being forwarded over the switch.

Not sure why it stopped or if something caused a STP reconvergence or something...anyway.. all is good now... thanks for you input

Darren

196
Views
0
Helpful
4
Replies