12-28-2007 05:31 AM - edited 03-05-2019 08:11 PM
Hi NetPro,
just have a quick check , with this command will only apply to Access switch only ? or deploy to Core-switches , Distribution switches ?
your reply will be highly appreciated.
thanks.
regards,
Jackal
Solved! Go to Solution.
12-28-2007 05:37 AM
Quick guess - access ports only.....
12-28-2007 06:27 AM
The command is configurable on any switch but in practice will be genrally configured on the access switches.
The Core/distribution switches would mostly carry only trunk uplinks or L3 routed ports and hence it is not configured
HTH
Narayan
12-28-2007 05:37 AM
Quick guess - access ports only.....
12-28-2007 06:27 AM
The command is configurable on any switch but in practice will be genrally configured on the access switches.
The Core/distribution switches would mostly carry only trunk uplinks or L3 routed ports and hence it is not configured
HTH
Narayan
12-28-2007 06:48 AM
Portfast is generally enabled on all ports to which the enduser desktops are connected.
Access switches are generally meant for that. So mainly on access switches or any desktop connected ports.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: