Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Bronze

spanning-tree vlan commands

hi every body !

I am preparing for ccnp(bcmsn) exam. I am using cisco press book by David Hucaby. In the book i find the command:

spanning-tree vlan vlan-id root{primary}\{secondry}

In the same book i find same command but this time with vlan-list option

spanning-tree vlan vlan-list root {primary} {secondry}

which one is correct?

I mean after vlan, It should be vlan-id or vlan-list?

Does hello timer for bpdu have any bearing on forward delay and max-age timer?

thanks a lot and have a nice day !

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: spanning-tree vlan commands

Hi,

They are both correct!

You can change the value for a single vlan, or you can change it for a range of vlans,

spanning-tree vlan 20,25,30 root primary

http://www.cisco.com/en/US/docs/switches/lan/catalyst3560/software/release/12.2_44_se/command/reference/cli3.html#wp1947142

HTH

LR

2 REPLIES
Silver

Re: spanning-tree vlan commands

Hi,

They are both correct!

You can change the value for a single vlan, or you can change it for a range of vlans,

spanning-tree vlan 20,25,30 root primary

http://www.cisco.com/en/US/docs/switches/lan/catalyst3560/software/release/12.2_44_se/command/reference/cli3.html#wp1947142

HTH

LR

Bronze

Re: spanning-tree vlan commands

thanks for your reply . could you please tell me if hello timer has any bearing on forward time and max-age timer.

thanks a lot!

461
Views
5
Helpful
2
Replies