Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Spanning Tree

Hi,

I would like to configure the spanning Tree the on switch A, switch B and switch C. All of them will connect to each other.

The traffic will go from switch A-> switch B -> switch C and stop it on switch C.

May I know how to find out whether there is a looping and how to test whether the spanning tree is configured successfully?

Is there any example for the configuration?

3 REPLIES
Cisco Employee

Re: Spanning Tree

It would be best to move this thread to an appropriate community to afford a more timely response.

Based on your question, you might want to move this to:

Network Infrastructure>LAN, Switching and Routing

Scott

New Member

Re: Spanning Tree

Thank for reminding me.

Purple

Re: Spanning Tree

If switch C is not attached back to Switch A then there is no inherent loop in the design.  I would just make switch "A" the root for all your vlans .

174
Views
0
Helpful
3
Replies