Segment 1: R1 with 2 swithces: 5 VLANS, ports trunked with dot1q, vtp was configured, sub-interfaces have been configured with different subnets for each VLAN, and everything is working just fine.
Segment 2 and 3: uplink ports and interswitching ports have been trunked with dot1q, vtp domain has been set; however, the VLANs from segment 1 aren't traversing to segment 2 or 3. What am I missing here?
From what I gather from your post, you are trying to propogate VLANs across a router (R1). It is not possible to route VLANs - the only way to do this is to bridge the interfaces on the router using IRB. Here's a good link on this:
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...