10-02-2007 03:35 AM - edited 03-05-2019 06:48 PM
Hi All
I need to configure spantree portfast and broadcast storms on all the interfaces on a live production switch. Can I do this on a production switch during production hours without impact to connecting users?
Thanks
Solved! Go to Solution.
10-02-2007 07:18 AM
Adetutu
Yes you should be able to configure portfast and broadcast storm on a production switch during production hours without causing impact on users.
HTH
Rick
10-02-2007 07:18 AM
Adetutu
Yes you should be able to configure portfast and broadcast storm on a production switch during production hours without causing impact on users.
HTH
Rick
10-02-2007 08:10 AM
Thank you very much
10-02-2007 08:43 AM
Adetutu
Thank you for using the rating system to indicate that your question was resolved (and thanks for the rating). It makes the forum more useful when people can read a question and can know that they will read an answer that successfully resolved the question.
I encourage you to continue your participation in the forum.
HTH
Rick
10-02-2007 12:21 PM
When you enable this on each port, it will reset the port. This takes like 2 seconds. Users will get a reset popup.
10-02-2007 02:20 PM
Configuring portfast on an operational port should have no effect. In fact, portfast only does something when the link is coming up. Once a link is up, portfast does not change much to the operational state (it just prevents the transmission of TC indication on the port).
Regards,
Francois
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: