Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Spantree portfast

Hi All

I need to configure spantree portfast and broadcast storms on all the interfaces on a live production switch. Can I do this on a production switch during production hours without impact to connecting users?

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: Spantree portfast

Adetutu

Yes you should be able to configure portfast and broadcast storm on a production switch during production hours without causing impact on users.

HTH

Rick

5 REPLIES
Hall of Fame Super Silver

Re: Spantree portfast

Adetutu

Yes you should be able to configure portfast and broadcast storm on a production switch during production hours without causing impact on users.

HTH

Rick

New Member

Re: Spantree portfast

Thank you very much

Hall of Fame Super Silver

Re: Spantree portfast

Adetutu

Thank you for using the rating system to indicate that your question was resolved (and thanks for the rating). It makes the forum more useful when people can read a question and can know that they will read an answer that successfully resolved the question.

I encourage you to continue your participation in the forum.

HTH

Rick

New Member

Re: Spantree portfast

When you enable this on each port, it will reset the port. This takes like 2 seconds. Users will get a reset popup.

Re: Spantree portfast

Configuring portfast on an operational port should have no effect. In fact, portfast only does something when the link is coming up. Once a link is up, portfast does not change much to the operational state (it just prevents the transmission of TC indication on the port).

Regards,

Francois

149
Views
0
Helpful
5
Replies
CreatePlease to create content