That is normal behavior and will "always" result in a speed/duplex mismatch . If you hardcode one side you have to hardcode the other, other leave both sides as auto , for the most part auto will work fine specially between cisco devices.
It also dependes and the devices network interface. We had some issue with Dell 520 not auto negotiating(auto/auto on both sides). It shows running full/100 but was getting a lot of CRC's. Once set to full/100 on both sides the crc's went away.
Setting the duplex mode on one side manually (to either full or half) and on the other side to Auto will always result that at the Auto side the duplex mode is half duplex. This because the auto-negotiation fails (as at the other side there is no peer with which to negotiate the duplex mode) and in such situation it fall-back to half-duplex.
This is a behavior specified in the standard.
As a result of that, setting manually to Full duplex at one side and to Auto at the other side will always result in duplex mismatch.
And to avoid this you have the choices:
- set auto at both sides (with some equipments auto-negotiation might not work corectly, so manual configuration is needed for those cases)
- set to full duplex at both sides
- set to half duplex at both sides (I listed this last option as well, even though this theoretical possibility should be never needed in reality)
One modification to the above posts should be noted.
If the auto-negotiated side is a Gigabit Ethernet interface, it will default to Full duplex. So, if you hard coded the other side to full duplex but left the Gig side as auto, you would not end up with a mismatch.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.