I have a 3825 router feeding a network of 2950C switches with a vlan per switch. Is there any way I can set user speeds for example to 25 mb on each user port on the switches in the router? I know the 2950C will not do this in their configs and I am getting pushback about upgrading the switches 3550s.
If I am reading you correctly I can set speed per vlan, or can I set speed per ip address in the vlan? IE on a 24 port switch on say Vlan20 on each port can I have 25mb on each ip on the vlan or would I have to have 24 different vlans on the switch?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...