Take note that though Cisco allowed us to force speed/duplex of GE interface (1000Mbps). Some server can't force the duplex of 1000Mbps to full-duplex.
If you think your server will not use up more t han 100Mbps bandwidth. It will be better to hardcode both server and switch too 100Mbps/Full-duplex than 1000Mbps/Auto.
Notably HP Unix servers. Some combination of NIC Vendor and Microsoft Windows have no option for 1000Mbps/Full-duplex.
Now, if you really want 1000Mbps. Make sure the ports (Switch and Server) are working fine and also the cable is in qood condition and for UTP it should be minimum Cat 5e. Also use traditional cable selection (i.e. use straight through cable instead of using Auto-MDIX). Then configure both ports (Switch and Server) to Auto/Auto.
This always works for me.
For additional info. Packeteer products with GE ports cannot force 1000Mbps/Full-duplex (only Auto/Auto if you really want 1000Mbps).
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.