This command is not necessarily specific to MST. This is a generic spanning-tree command which can be used in all modes.
As Reza explained, the spanning-tree portfast trunk, enables the portfast feature on a trunking interface - configuring just spanning-tree portfast on a trunking interface has no effect. This is most commonly used when you have trunked interfaces that go to servers, etc.
The spanning-tree portfast default command is an easy way of enabling the portfast feature on all access ports instead of going into each interface and enabling it one by one.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...