cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
371
Views
0
Helpful
1
Replies

SPS2024 802.3ad issue

alexeyk53
Level 1
Level 1

Hi all.

I have setup SPS2024 link aggregation(802.3ad) with two hosts: the one side four 1g ports
Solaris 11 aggregation (storage), the one side two 1g ports Linux bonding (client).
The tests shows normal distribution of a sending traffic over several ports on both hosts, but only
one port used for receiving, so only 1 gigabit utilized. Setup multiple IP aliases or tuning port
selection policies is nothing changing.
Distribution of inbound traffic on a host do right way (two or more ports used) only if one of LAGs
is destroyed and sending side works like common clients with 1g port.

The question is: is this restriction imposed by 802.3ad specification or just property of the certain
switch model? Is there a workaround?

1 Reply 1

alexeyk53
Level 1
Level 1

Probably, I should  suppose nobody aware such kind of problems.

Very sad.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: