We have recently purchased the Cisco SRP547W and I have managed to translate most of the settings from our current Billion router in to the Cisco with the exception of Firewall Packet Filters (which ports to allow in and out). Here is an example from our Billion router.
Source IP / Netmask
Destination IP / Netmask
0.0.0.0 / 0.0.0.0
0 ~ 65535
0.0.0.0 / 0.0.0.0
80 ~ 80
I have been through the Admin guide, the forums and the router itself but can't find where to specify these. Anyone have any experience with this router?
Also the only other thing I am not sure about is setting the GRE protocol. In the Billion models it’s a simple setting under port forwarding. Am I correct in assuming its already part of the PPTP protocol?
The one thing I am disappointed about this router is you are limited to 10 static routes. We have much more than 10 configured on our current router so I guess we just have to work with this limitation. Ideally we would like a similar router without the VOIP capability that can accommodate more than 10 static routes. My IOS commands are very rusty as I haven't had to use them in many years so would prefer the GUI interface. Any suggestions?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.