Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SRR - Shape and Share command on interface

Hi, I am having trouble understanding the following configuration:

srr-queue bandwidth share 10 10 40 40

srr-queue bandwidth shape 100 0 0 0

queue-set 2

The Cisco documentation says "If the egress priority queue is disabled and the SRR shaped and shared weights are configured, the shaped mode overrides the shared mode for queue 1, and SRR services this queue in shaped mode" so why would anyone bother configuring both a shaped and a shared mode if the shaped is going to take priority?

2 REPLIES

Re: SRR - Shape and Share command on interface

srr-queue bandwidth shape 100 0 0 0

Because the weight ratios for queues 2, 3, and 4 are set to 0, these queues operate in shared mode. The bandwidth weight for queue 1 is 1/100, which is 1 percent

HTH

Narayan

New Member

Re: SRR - Shape and Share command on interface

I see. Where does the formula 1/100 come from?

299
Views
4
Helpful
2
Replies
CreatePlease login to create content