Have a new SRW2008P. I can connect to the web interface just fine, and it switches packets without any problems. Web interface says POE is enabled on all 8 ports, but "Mode" is "off" for all eight ports. If I plug in a Polycom IP501 phone I get nada. A voltmeter across pins 4 and 8 is zero volts. Is the POE circuitry in this switch fried? Or am I missing a setting to turn it on?
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...