Is it possible to use SFP transceiver Cisco GLC-FE-100LX into the Cisco-Linksys switch SRW208P?
I know that officially for Cisco SMB switches are intended MFELX1 transceivers, but the situation is that we on the field have GLC-FE-100LX transceivers, so if it could be possible to enable in configuration usage of GLC transceivers on SRW208P switch it will be the best solution. Like it is possible on Cisco Catalyst switch with “service unsupported-transceiver” command?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...