Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ssh forwarding port

Is it possible to change the ssh 22 -->800 port on a cisco switch?

1 REPLY
New Member

Re: ssh forwarding port

Complete these steps to configure Secure Shell (SSH) to the PIX Firewall:

Before a connection to the PIX is made through SSH, these prerequisites must be met:

The PIX must run version 5.2 or later.

The PIX must have a VPN Data Encryption Standard (DES) license, as indicated in the output of the show version command.

Note: Refer to Product License Registration in order to request a DES license.

Once all requirements are met, issue these commands on the PIX:

hostname domain-name

!--- Generate a key for the SSH encryption to use.

ca generate rsa key 1024

!--- Allow the desired host to connect to the PIX on the interface specified.

ssh ip_address mask interface

!--- Save your configuration.

ca save all

write memory

This is an example:

hostname mypix

domain-name cisco.com

ca generate rsa key 1024

ssh 10.0.0.0 255.255.255.0 inside

ca save all

write memory

Refer to the SSH - Inside or Outside section of How To Perform Authentication and Enabling on the Cisco Secure PIX Firewall (5.2 Through 6.2) for more information.

315
Views
0
Helpful
1
Replies
CreatePlease to create content