I have an switch 2960 and i have made an SSH connection . But the problem is that whenever i try to open with my teraterm or putty it ask for username and after that password but does take the password. It shows an error of password what should be the problem.
The title of this thread is that SSH is not working. But I believe that if you get the prompt for user name and password that SSH is working because if SSH were not establishing the session then there would not be a prompt for user name and password. It sounds like the problem is in authentication (or perhaps authorization). The best way to verify whether SSH is working is to use the command show ip ssh. If it comes back and tells you what version of SSH is enabled (should be version 2 according to your post) then SSH is working.
I agree that it may be helpful to see the configuration of the vty lines. It would also be helpful to see the configuration of aaa.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.