Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SSH Server Version

I just purchased a 3845 router and I am trying to find out how to make sure the router is running ssh v2 and if not what the command is to make it run that version.

Thanks

Pete

2 REPLIES

Re: SSH Server Version

From the CLI-

CORE#show ip ssh

SSH Enabled - version 1.99

Authentication timeout: 60 secs; Authentication retries: 3

CORE#

This is running version 1. To enable version 2, go into config mode and enter-

CORE(enable)#ip ssh version 2

CORE(enable)#end

CORE#show ip ssh

SSH Enabled - version 2.0

Authentication timeout: 60 secs; Authentication retries: 3

CORE#

HTH and please rate.

Hall of Fame Super Silver

Re: SSH Server Version

Petros

To check the version use the command: "show ip ssh". If it is not running version 2, you can use the command: "ip ssh version 2" (assuming that the router is running a version of code that supports version 2). If the code you are running does not support version 2 (I believe it requires 12.3T or 12.4) then you obviously must upgrade code to get to version 2.

HTH

Rick

210
Views
8
Helpful
2
Replies