Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SSO Redundancy mode

Hello,

Working with a 6500 chassis running on a single SUP720-3B.

For some reason, the power redundancy mode is showing "mode sso".

What's the proper config mode for a single sup chassis and how to change that?

redundancy

mode sso

main-cpu

auto-sync running-config

Thanks

Jeremy

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: SSO Redundancy mode

Hello Jeremy,

as Kevin has noted these commands should have no effect on your single supervisor chassis.

they are probably inserted by default in the IOS image you are using to make the system ready for addition of a second supervisor.

Hope to help

Giuseppe

4 REPLIES

Re: SSO Redundancy mode

You don't need worry about those commands since you only have one SUP. It won't impact anything.

Hall of Fame Super Silver

Re: SSO Redundancy mode

Hello Jeremy,

as Kevin has noted these commands should have no effect on your single supervisor chassis.

they are probably inserted by default in the IOS image you are using to make the system ready for addition of a second supervisor.

Hope to help

Giuseppe

New Member

Re: SSO Redundancy mode

Giuseppe,

I have a very strong feeling that the sso mode is inserted by default in the ios image but I haven't come accross any documentation to support that.

Have you?

Thanks

Hall of Fame Super Silver

Re: SSO Redundancy mode

Hello Jeremy,

I have experimental evidence in a campus with 6509 used as distribution switches I see:

sh run | beg redundancy

redundancy

keepalive-enable

mode sso

main-cpu

auto-sync running-config

!

sh ver | inc image

System image file is "disk0:s72033-advipservicesk9_wan-mz.122-33.SXH2.bin"

on other systems running 12.2(18)SXF14

h run | beg redundancy

redundancy

mode rpr-plus

main-cpu

auto-sync running-config

auto-sync standard

!

sh ver | inc image

System image file is "sup-bootflash:c7600s72033-advipservicesk9_wan-mz.122-18.SXF14.bin"

all these systems have a single processor on the chassis.

Actually, 12.2SXH config guide says that you need to enter mode sso in redundancy config mode to have SSO but there is evidence it is enabled by default because it is the basis for NSF operations.

Hope to help

Giuseppe

1721
Views
4
Helpful
4
Replies