I connected two Catalyst 3550 with the GigaStack Gigabit Interface Converter. This will permit me to connect the switches in a cascade stack configuration.
I assigned an IP to both switches, and they can ping each other, so I know my Gigastack is working.
My question is, when I do a "show interface" on one of the switches, is there a way to see the interfaces of both switches? Presently, even if they are connected via the gigastack module, I still need to manage both switches individually.
Is there a "switch provision" command like the 3750 series, which will permit me to see the stack as one switch?
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...