Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

stack ports down on a 2 sw3750 stack

hi all ,

i have some 3750 stack (2 switchs) same ios in each ,

stacked port 1 to 2 and 2 to 1 (an X) ios 12.2.25 SEE1 crypto , and with sh switch stack-port i see a link down (port 1 sw1 and port2 sw2 ie)

stackwise version is 1.14 on both, is there a bug with this version or did i missed smthing ? is there some bads stacking cables ?

any idea or link would be useful

2 REPLIES

Re: stack ports down on a 2 sw3750 stack

Can you check the stackwise connection for bent pins? this is usually the cause for a damaged cable.

you can try replacing it with a new stack cable and check whether the error disappears or not

Narayan

Purple

Re: stack ports down on a 2 sw3750 stack

Make sure the cables are tightened all the way down , they can look like they are tight but are not . tighted to finger tight or use a screw driver but do not over tighten just till snug .This is not my favorite platform . You try to upgrade them them and they don't upgrade correctly even when you follow cisco instructions to the T , spent an hour the other nite upgrading a stack because i kept getting version mismatch and it wouldn't boot correctly even with the boot system switch all boot parameter.

246
Views
0
Helpful
2
Replies