Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

stack with 3750-48TS

Hi:

Should I connect the port-1 of the swith-1 to the port-2 of the swith-2 to enable the stack?

What happen if I use the port 1 in both switches? It should work, right?

Regards.

1 REPLY
Purple

Re: stack with 3750-48TS

Yes port 1 to port 2 on the 2nd switch . If you add a 3rd , it would go 1 to 2 on the third and then you would run port 1 on the 3rd switch to port 2 on the first switch to make it redundant.

108
Views
0
Helpful
1
Replies