Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Stacked 3750 lost Configuration

I have 2 3750 Stacked and was working properly. Recently we had a power problem and power was lost to both switches simultaneously,when power was restored both switches lost their configuration, as if they are new or factory reset.I had to reconfigure again.

What would cause this to happen and what can be done to prevent this in the future.

Thank you

Basky Ramdeo

5 REPLIES
Hall of Fame Super Gold

Re: Stacked 3750 lost Configuration

1. Someone didn't save the config.

2. Someone changed the config filename.

3. Someone configured the appliance to boot and use a different filename or location

4. Hardware failure.

New Member

Re: Stacked 3750 lost Configuration

Thank you for your response leo.

Hmmm actually the configs was saved, i also had a backup on text which i used to get it up an running again quickly.No one supposed to have access to the switches to make any changes.Also they are still working after reconfiguration therefore not sure about the hardware failure. I do know it happened after power failure but no hardware part were changed afterwards.

Regards

Basky

New Member

did you find out what was the

did you find out what was the problem?

 

Thanks.

New Member

Re: Stacked 3750 lost Configuration

I have a single Cisco 3750G-24TS -S1U V03 lost its config twice in 1 year.  I end up taking it out of service.  Not sure what is going on. I'll see if I can RMA it since it is under smartnet contract.

New Member

Re: Stacked 3750 lost Configuration

I believe it may be kind of hardware failure or a kind of bug running on this device. It's better to go for hardware replacement,

571
Views
5
Helpful
5
Replies