cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1582
Views
0
Helpful
6
Replies

STACKMGR-5-MAJOR_VERSION_MISMATCH

vilvalenciennes
Level 1
Level 1

hi everybody,

I'm experiencing a strange behaviour on a catalyst 3750-48PS-S.

In the system log appears "%STACKMGR-5-MAJOR_VERSION_MISMATCH: Major Version Mismatch (Local 1 - Received 3) with neighbor-1"

but this is not a stack :

#sh switch
Switch/Stack Mac Address : 0012.43ad.8c80
                                           H/W   Current
Switch#  Role   Mac Address     Priority Version  State
----------------------------------------------------------
*1       Master 0012.43ad.8c80     1      0       Ready

#

I updated ios from 12.2(55)SE1 to 12.2(55)SE4 with no change.

someone got any idee ?

thank you

1 Accepted Solution

Accepted Solutions

I have some bad experience with some 16mb 3750.  Mostly caused by the stack controller failing.  If you have a service contract then get this switch replaced as you can't determine whether or not the issue is going to get worst.

View solution in original post

6 Replies 6

Leo Laohoo
Hall of Fame
Hall of Fame

Sounds like a hardware failure to me.

Can you try to post the output to the command "sh post" please?

When this is done, can you reboot the switch and see if you are still getting the same issue?  I'm running 12.2(55)SE4 and I have not seen this error message in our fleet of 3750 of >100 stacks.

Thank you for this answer.

here the show post result

SW#sh post
Stored system POST messages:

Switch 1
---------

POST: CPU MIC register Tests : Begin
POST: CPU MIC register Tests : End, Status Passed

POST: PortASIC Memory Tests : Begin
POST: PortASIC Memory Tests : End, Status Passed

POST: CPU MIC interface Loopback Tests : Begin
POST: CPU MIC interface Loopback Tests : End, Status Passed

POST: PortASIC RingLoopback Tests : Begin
POST: PortASIC RingLoopback Tests : End, Status Passed

POST: Inline Power Controller Tests : Begin
POST: Inline Power Controller Tests : End, Status Passed

POST: PortASIC CAM Subsystem Tests : Begin
POST: PortASIC CAM Subsystem Tests : End, Status Passed

POST: PortASIC Stack Port Loopback Tests : Begin
POST: PortASIC Stack Port Loopback Tests : End, Status Passed

POST: PortASIC Port Loopback Tests : Begin
POST: PortASIC Port Loopback Tests : End, Status Passed

SW#

Everything seem fine

I already rebooted it and i did it again. The error message could appear a few days later.

I'll post here if this is the case

regards

This isn't one of those models with 16 mb flash is it?

Yes it is.

Maybe i should downgrade to IP Base ?

I have some bad experience with some 16mb 3750.  Mostly caused by the stack controller failing.  If you have a service contract then get this switch replaced as you can't determine whether or not the issue is going to get worst.

Ok.

Thank you for your help

Review Cisco Networking products for a $25 gift card