Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

StackWise problem with CPU load and SSH?

Anyone seen an issue where doing a "show run" pegs the CPU on a switch that's in StackWise? We have a 6x 3750 stack running 12.2(55)SE and when we do show run the CPU goes to 95% or higher. Often SSH will be at 50-70% of the CPU. A 2x 3750 stack running 12.2(53)SE2 still hits 47% for SSH on the same thing while a lone switch only hits ~13% for SSH.

Thoughts?

Leam

1 REPLY
Cisco Employee

Re: StackWise problem with CPU load and SSH?

Hello Leam,

Two questions for you:

- can you provide me with the output of "show proc cpu | exc 0.00" while the issue is happening?

- do you see the problem even when you are consoled into the switch or is it specific to when you use SSH/Telnet?

Fabienne

339
Views
0
Helpful
1
Replies
CreatePlease login to create content