Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Standard Named ACL Sequencing

Below is the current ACL

    10 permit 192.168.56.49 log
    20 permit 192.168.56.50 log
    30 permit 192.168.56.51 log
    40 permit 172.16.30.47 log
    50 deny   any log


If I try to change the numbering of the ACL so 172.16.30.47 is second in the list it looks like

    20 permit 192.168.56.49 log
    30 permit 192.168.56.50 log
    40 permit 192.168.56.51 log
    10 permit 172.16.30.47 log
    50 deny   any log

 

So given the order of the ACL from show access-list is the ACL being processed in sequential order by sequence number or top/down order?

4 REPLIES

Hey,It will use the sequence

Hey,

It will use the sequence number.

Regards,

RS.

Purple

  It should be by sequence

  It should be by sequence number .  If you want the 172 as second try using sequence number 11  for that entry .

New Member

My example was bad, it would

My example was bad, it would have made 172 the first entry.  I've tried doing as you mentioned, but the show access-list output order will look like this

 

10 permit 192.168.56.49 log
30 permit 192.168.56.50 log
40 permit 192.168.56.51 log
11 permit 172.16.30.47 log
50 deny any log

Hey,As i mentioned in last

Hey,

As i mentioned in last post, its always the sequence number.

10 permit 192.168.56.49 log - 1
30 permit 192.168.56.50 log - 3
40 permit 192.168.56.51 log - 4
11 permit 172.16.30.47 log - 2

HTH.

Regards,

RS.

33
Views
0
Helpful
4
Replies